Steps a task that must Mraatha when installing Paper Walls

Steps a task that must Mraatha when installing Paper Walls

عليك بالتأكد من بداية اTo paint or the form found on the wallpaper because it is affixed to the top as we mentioned before, hold parties, which will be hung up and Ferdhm and start the line of the balance of water out to the left, and the same is followed with a wall of higher education thread of water at the ceiling. Singled out the paper from top to bottom from the central region and then to the outside using a brush or a piece of soft sponge with the removal of any signs of an instant, or any spaces for air Place the following segment next to the segment that preceded the same way (not trying to attract, if the paper there was an error in the installation, but unplug them whole, and re-paste it again in the case of inconsistencies in the seam line that exists between each piece and the other.) Prohibited the development edge of the paper over the segment that preceded but should be the edges next to each other. In order not to see any breaks put pressure on a piece of sponge soft after about 20 minutes to install the paper, as is cleaning the pluses of adhesive or putty is used in the installation process between the intervals and at the ends (the ceiling or Mizar) with a sponge wet before it dries. For more trust you to install three pieces of paper and then just wait to see the result for a day at most. to get rid of redundancies surfaces using a knife, taking care of the destruction of paper that is installed on the wall.

Installation of the wallpaper in the corner
Do not install the paper in one piece as a whole when there is staff but there should be a line of docking at the corner, which links Alhaitin, you must measure the wall of the end of the last piece you placed on hold until the corner with the measurements of many, starting from the top of the wall on the roof and at the center until the Mizar you will find different view. Pieces of wallpaper sized more than 1 / 2 cm from the measurement I took (with retention Palmtbaki). This piece attaches the end of the last piece hanging on the wall until you reach the level of the corner. Uses the remaining part at the beginning of the commentary at the wall of the new measured view and teaches on the wall of this new size, then comes the role of the thread of water to ensure the integrity of the paper and learn the wall and then start to paste from the brand and then to the inside (there may be redundancies will overlap with the interval latter does not need to get rid of them However, re-paste adhesive is more stable than vinyl(Vinyl). 

Installation of wallpaper around doors and windows:

Installed on the framework paper doors and windows so that they are appendages to the window, and then cut with scissors, leaving a few inches around the sides of the frame as a whole. If there are certain corners of the paper around the settlement at par with no boundaries, and then settled in a final stage with a knife surfaces.nstallation sheets Alosag:
If you paper for the roof will be installed must be preceded by the installation of this paper, papering walls, hanging paper in a narrower area of the roof of the room. Measured width of the paper and then minus 1 / 2 cm, is measured by the width of the pillars of the shortest wall and put pins are small at this measurement, set the thread by the chalk color on these screws and pull the middle and then left suddenly to paint a straight line like the previous steps you need to measure the length and cut paper But the size and longer business as usual and after placing the sticker and leave it for a bent paper Bttiyat accordion-like machine and then left for a few minutes. Is to use a broom to an individual paper on the roof and another person, open the first fold, and so one after the other against the guideline to stick in the end and leave a trailing space 1 / 2 cm on to face with the paper, which is installed on the wall.

Installing the wallpaper on the keyboard electric: 

عليك بفConnect the power supply before working on electric keyboard, and remember that water is included in the installation process. During the individual paper on the wall, sticks them with no problems like a part of the wall and after the completion of the installation of paper clipped in the middle of the board and cut diagonally at right angles to each corner of pressure on the paper at each edge, with the knife to get rid of redundancies.
Repair damaged from wallpaper:
Is drawn with a new take, a small fragment by the damaged part and even more than a little stuck somewhere harmony with set painting for the co-ordinated with the rest of the paper and then used a knife to cut both layers of new and old, are disposed of class paper of old, redundancies and re-development of the new piece place piece of old
.